![]() There's also a rewind knob on ebay right now for $15 plus shipping. If it's still there and you're only missing the tiny screw, you could probably either drill it out and replace it with another tiny screw or put a spacer of some sort in the place where the head should have gone (eg, glue a tiny thing in there). Essentially an normal rewind crank such as on the M6 is simply a handle attached to the spindle which slots onto the film canister. It helps make sure that the lever stays in the right place and the wire axle for the lever stays in place. Cheers guys.ĭid the whole knob fall off? If so, I hope you didn't lose the spring that sits under the knob. I think I'll look for a broken one in the UK and cannibalize it for parts. High speed automatic rewinder Machine is new design by Wintech plastic machinery ,this autoamtic rewinder machine work for stretch film or clinig film rewin. There's an OM-1 going for parts at KEH or you could look up John Hermanson and see whether he can help. Parts will probably need to be cannibalised from a broken camera. See here on the removal of the top, step 2: /Hardware/tutorials/OM-1CoverRemoval/. At the end of film rewind, you will feel a slight resistance. It only has one purpose: to make the crank arm sit flush. Lift the film rewind crank and turn it in the direction of the arrow. Well, the tiny screw on the top should never be removed and normally is so tight that makes it very difficult to remove. I'm worried the same thing will happen again.ĭoes anyone happen to have a spare chrome rewind knob? Or can you advise me where I can get spare parts? I've re-attached the rewind knob, but now the crank arm doesn't sit flush in its slot and the whole thing feels a bit wobbly. ![]() Received 30 July 2015 accepted 16 February 2016 published 19 February 2016. ![]() I've never come across this before and I have no idea how it happened. (2016) Intelligent Winding Machine of Plastic Films for Preventing Both Wrinkles and Slippages. ![]() When I got home and was able to take a closer look I realized that the head of the tiny screw which sits under the rewind crank arm and goes into the centre of the rewind knob has sheared off. You need to slide the film rewind lever, located just behind the shutter speed dial, to the right, and press. After a lot of fiddling about I managed to reassemble it temporarily so that at least I could finish rewinding the film and remove it, but it clearly didn't look or feel right. I had finished a roll of film and was rewinding it when the rewind knob fell off and came apart. I'm hoping one of you kind folks may be able to help me out. Yesterday I was out shooting with my OM2N when I had a minor mishap. ![]()
0 Comments
Leave a Reply. |